<>
follow




DISCLAIMER POSTS HIT IT
Nur Farhana binti Shahrul Azhar
51215116027
Bachelor of Engineering Technology in Medical Electronics

This blog is created for updating progress of Final Year Project 2 S2 2019 under supervision of Mr Shah Rizailli Mukhtar

Final Year Project 2 :
Development of a Characteristics Error False Alarm Detection

P/S : For newest post, click Home icon on the lower part, right side of the blog.

"Even with broken wings,
I'll teach myself to fly again"
Week 8

Assalamualaikum and hi! 🌸

Week : 8
Date  : 8 Sept 2019 - 14 Sept 2019

Activities :

 1.  Evaluation progress of the project.

πŸ“†  11 September 2019
⌚  3.00 pm
πŸ“¬  FYP room


πŸ“Œ Supposedly, the evaluation progress needs to be conducted in the FYP room but due to too many students in that room, the test conducted in BMR 215. 
πŸ“Œ Filtering circuit constructed on the breadboard to filter the noise and set a bandwidth. Based on the data collected on Final Year Project 1 using the patient monitor, the range of the frequency general alarm is from 500 Hz to 525 Hz. A bandpass filter is constructed using an amplifier LM741, capacitors 47nF, resistor 5.6k ohm and 6.8k ohm.


Sound sensor circuit with signal conditioning.
*click to expand image*

πŸ“Œ Due to the unavailability of the patient monitor in BMR 215, the filtering circuit cannot be verified. The next test must be conducted in SPS 209 because of the availability of the patient monitor there to verify the filtering circuit.
πŸ“Œ The video for observation can be seen here >> Signal Conditioning Circuit


 2.  Testing signal conditioning circuit with medical equipment.

πŸ“† 13 September 2019
⌚  12.15 pm
πŸ“¬  SPS 209


πŸ“Œ This test in the continuing of the progress on September 11, 2019 with the addition of the usage of medical equipment. 
πŸ“Œ An oscilloscope is connected to the circuit to observe the waveform characteristics in the form of amplitude, frequency and cycle.

Sound sensor circuit with signal conditioning.
*click to expand image*


 3.  The layout of sound sensor circuit with signal conditioning

πŸ“†  14 September 2019

πŸ“Œ This is the sketch of the sound sensor circuit with signal conditioning by using Fritzing software for the sketching on a breadboard, a stripboard and a PCB board. There is also the schematic diagram of the circuit using Proteus 8 Professional software.


Breadboard view and stripboard view using Fritzing software.
*click to expand image*

PCB board view using Fritzing software.
*click to expand image*

Schematic diagram of circuit using Proteus 8 Professional software.
*click to expand image*


"For every reason it's not possible, there are hundreds of people who have faced the same circumstances and succeeded." 
Jack Canfield

Post a Comment



<< home >>

FINAL YEAR PROJECT 2
Development of a Characteristics Error False Alarm Detection